Stainless steel tanks for water reservoirs formed by: deposit, mechanical float valve for the control of filling the tank, filter for impurities, minimum level switch, ball valvefor the aspiration hose of the group, drain valve installed at the lower part of the tank for maintenance, closing lid with air vent, connection hose to the pump and level view glass.
Polyester tanks reinforced with fibreglass (FRP) for water reservoirs formed by: deposit, mechanical float valve for the control of filling the tank, filter for impurities, minimum level switch, ball valve with connector for the aspiration hose of the group, drain valve installed at the lower part of the tank for maintenance, closing lid with air vent and connection hose to the pump.
| Reference | Capacity |
| AN/D500V | 500 |
| AN/D750V | 750 |
| AN/D1000V | 1.000 |
| AN/D2000 | 2.000 |
| AN/D3000 | 3.000 |
| AN/D4000 | 4.000 |
| AN/D5000 | 5.000 |
| AN/D6000 | 6.000 |
| AN/D7000 | 7.000 |
| AN/D8000 | 8.000 |
| AN/D9000 | 9.000 |
| AN/D10000 | 10.000 |
| AN/D11000 | 11.000 |
| AN/D12000 | 12.000 |
Normally closed high-pressure directional valve, formed by: ball valve of PN400 stainless steel, pneumatic piston, lever for manual opening, solenoid for electric triggering for the automatic opening and flanges for its fixation to the collector and aconnection to the installation tubes.
AN/VD38. Directional valve 3/8 diameter (inches)
AN/VD12. Directional valve 1/2 diameter (inches)
AN/VD34. Directional valve 3/4 diameter (inches)
AN/VD1. Directional valve 1 diameter (inches)
AN/VD114. Directional valve 1 1/4 diameter (inches)
Test run set for control until 14 valves
